Automatic System Control AquaSolar® for Enersol Pool Heaters
The AquaSolar® system from GoldLine Controls gives you total solar system control with digital display of pool temperature and solar system temperature, plus, full system diagnostic LED’s. The Aqua Solar is set by a single dial adjustment for desired pool temperature. The AquaSolar® offers selectable high limit, programmable re circulation freeze protection (with an extra sensor available as an add-on) and nocturnal cooling to customize any installation.
Contents of box:
- 3 way manual valve
- actuator
- control box
- 2 sensors
- 4 long screws
Features:
• Microprocessor based = digital accuracy
• Digital temperature display for pool, solar and auxiliary sensors
• Large, enamelled metallic enclosure
• Re-circulate freeze protection (field selectable)with extra sensor available as an add- on
• Nocturnal cooling (field selectable)
• 120/240VAC input power
• 24VAC low voltage output (for valve)
• Up to 2 plug-in 3HP relays can be used for:
- booster pump control
- time clock override
- pool sweep interlock
- solar priority
Sensors:
Installation of the 10K water sensor:
Drill a 5/16″ hole into the incoming water pipe, usually between the filter and diverter valve (feed line).
Install the plastic cylinder shaped sensor into the 1 1/2″ PVC pipe to sense the water temperature.
Wires go through the hole in the stainless gear clamp and are clamped tight.
Use wire connectors (marr caps) for connecting the sensor leads to the sensor wire (2 line phone cord).
Tie a knot in the cable wire and sensor leads to act as a strain relief. Wrap with electrical tape for extra protection.
Installation of the 10k roof sensor:
Install the black sensor on the roof where it receives sunlight similar to the solar collectors. Install on the roof, not on the panels.
Use the TEK screw to mount to the roof.
Use wire connectors (marr caps) for connecting the sensor leads to the sensor wire (2 line phone cord).
Tie a knot in the cable wire and sensor leads to act as a strain relief. Wrap with electrical tape for extra protection.
How to attach the Goldline Valve Actuator to the manual valve:
-Remove the handle from the 3 way valve
-set the actuator on top of the 3 way valve
-line up the splines on the shaft and slide the actuator onto the valve ( it should only fit one way) and note which screws on the 3 way valve correspond to the holes on the actuator
-remove the 4 short screws on the 3 way valve that correspond to the 4 holes on the actuator slide the actuator and 3 way valve together and using the enclosed long screws, join together
- replace the handle on top of the actuator
Download Data Sheet:
Download Installation and Operation Manual:
AQUA SOLAR™ Operation and Installation Manual
Price:
Send Inquiry- Email to a Friend
